InkStitch - embroidery patch

Draft

Objectives

• Create embroidery patches

See also

• Computerized embroidery

• Quality: to improve

• Difficulty: intermediate

Introduction

Creating a patch with only an embroidery machine is feasible, but requires a little bit of precision work.

Creating patches is explained in general terms in the Embroidery patch article. Here, we just summarize one method

• Cut out some fabric of the size of the badge. You can print out a paper version of the design and use it as model. We use our Trotec Speedy 100R 50Mw laser cutter with settings: power=22, speed=1.9 and Hz=1000.
• Hoop a self-adhesive tear-away stabilizer, sticky side up. Consider using two layers.
• Stitch a placement stitch (cut line) that has the size of the patch.
• Remove the hoop
• Stick the precut fabric inside/on top of the cut line. (If you don't have a sticky stabilizer, glue the fabric)
• Put the hoop back
• Stitch an optional tackdown stitch followed by a zig-zag border first.
• Then stitch the rest of the embroidery.
• Carefully remove the patch. You now can just stick a piece of stabilizer on top of the round hole and start again without re-hooping. If well done this will last for at least 10 patches.

Cutting fabric for embroidery patches

It is probably best not to stitch a background color. Otherwise you will have to manage a pull/push effect and also make sure that the overlap between border and background looks good. The zigzag stitch should come first in order to make sure that it is correctly placed along the borders. Instead, use specialized fabrics for batches that look good, e.g. Twilly or Step from Gunold.

Templates

Below are 6.1cm templates with rather narrow zigzag border. You will have to put something inside]

Patch templates

[[File:inkstitch-patch-61-5mm.svg|thumb|250px|none|SVG model for creating 61.5 mm patches. Heavy ZigZag underlay, no tackdown/fixing "line"]

[[File:inkstitch-patch-61-5mm-V2.svg|thumb|250px|none|SVG model for creating 61.5 mm patches. Tackdown/fixing "line and a ligther ZigZag underlay"]

[[File:inkstitch-patch-80-mm-V1.svg|thumb|250px|none|SVG model for creating 81.5 mm patches. Tackdown/fixing "line and a ligther ZigZag underlay"]

InkStitch example

Version 1

SVG model InkStitch Logo patch

Simulation

First test

This design has quite a lot of pull. One probably could make the blue frame a bit smaller and use less density. The border may have to be improved (less underlay) and the placement stitch made a bit bigger. The hooping probably wasn't perfect. We should have used two layers of stabilizer.

Version 2

SVG model InkStitch Logo patch

Second test