Fokoos Odin-5 F-3: Difference between revisions

The educational technology and digital learning wiki
Jump to navigation Jump to search
 
Line 22: Line 22:
* Supported filament: PLA/PLA+/TPU/ABS/PETG
* Supported filament: PLA/PLA+/TPU/ABS/PETG
* Official slicer: FOKOOS Slicer based on Ulimaker Cura
* Official slicer: FOKOOS Slicer based on Ulimaker Cura
 
* Typical print speed for PLA: 80mm/s and less for walls (max speed is 300)


== Liens ==
== Liens ==

Latest revision as of 16:24, 14 April 2023

Draft

Introduction

The Fokoos Odin-5 F-3 is a low-cost printer made by Fokoos

The author of this article bought one in fall 2022 at Fnac (France). At half its price (200 Euros) I consider it a very good buy. Assembly and calibration was very quick (about 15 minutes for unpacking and assembly) and 10 minutes for calibration of the bed. I did not make any modifications since it does its job (mostly printing LEGO/Duplo compativles or some simple household appliances).

It prints TPU, PLA and PETG without any problems. However, the glassbed requires "hairspray" to make the PETG and the PLA stick well. To remove prints I use a hammer (slight tap) once the bed is cooled down.

Specifications

  • 235 x 235 x 250mm build volume
  • (Proprietary) direct extruder with a volano 0.4mm nozzle
  • Nozzle max temp = 260
  • Bed max temp = 120
  • Supported filament: PLA/PLA+/TPU/ABS/PETG
  • Official slicer: FOKOOS Slicer based on Ulimaker Cura
  • Typical print speed for PLA: 80mm/s and less for walls (max speed is 300)

Liens